M16545 Filter Replaces Remington Heaters Review

The plastic case is cheap and broken. The cork gasket doesn't seal properly, which eventually causes the screws to tighten and the plastic to crack, rendering it unusable. I ended up not using any of these parts. Fail.

Fine but plastic plate torn on arrival Tried to fix it with super glue because I didn't have to wait but plastic just fell apart Filters worked perfectly Plastic was either old or new made very poorly, i tried to make metal in my shop and got on with my life.

The plastic case is cheap and broken, the cork gasket does not seal properly resulting in the screws being tightened and the plastic cracking rendering it unusable. I ended up not using any of these parts. Fail.

Everything is as it should be but the plastic panel ripped on arrival, they tried to fix it with superglue because they didn't have to wait but the plastic just fell apart Filters worked fine, the plastic was either old or just very poorly made, I tried, I ended up making metal in his workshop and moving on with his life.

The product is usable. I had a cracked case that needed replacing. The case fit and sealed, so my air pump worked again. BUT the parts assembler sent two identical "vent plugs". If I couldn't reuse what I had, this set wouldn't work. Finally, I had to cut the foam filter to fit. I feel petty for mentioning this, but not everyone will be comfortable with it. Therefore only 3 out of 5 stars because of the quality.

I had a masterpro 135000 btu kerosene salamander. It did not work. Took it apart to see what was going on, cleaned the air pump, checked the igniter and bled air through the fuel line to the injector, it worked. The plastic backplate was found to be cracked, preventing the pump from delivering air to the injector. I put this new plate and filter in place and the heater started working right away! Was very happy. NOTE The air pressure regulator is NOT pre-installed. You need to assemble it and…