🔧 Makin's Ultimate Clay Machine: The Ultimate Choice for Professional Clay Crafting Review

Being new this product works for what I need, but I wish there wasn't such a sharp gap between larger and smaller settings. Most settings seem too fine to use (sound becomes wavy). I would also have preferred thicker settings. A small note is that the handle often falls out. It's minor but annoying. This is how it works for me as a beginner, but it has its downsides.

I was very pleased with the performance of this machine. Easy to use and clean. It's nice that it's wide. However today, after less than two months of ownership and regular/normal use, the handle has broken. There is no easy way to get to the screw inside to reattach it. I'm heartbroken because it was a big investment for me. I'm not new to working with polymer clay. I've used younger models and before that it wasn't like that. (However, my Atlas pasta machine is holding up great) My machine…

This clay machine is the best deal. It's also very durable. I especially like that the rollers are not metal, plasticine does not stick to them. Cleaning is also very easy, I just wipe it down with an unscented baby wipe and then a dry paper towel. While the clip holds perfectly, I cut off a small piece of the shelf/drawer liner to put under the car as my surface is a thick piece of countertop glass. The handle is detachable, so sometimes you need to put it back in when using it for larger…

I finally replaced my old, broken and cheap polymer clay machine with this AHMAZING Makins Ultimate Clay Machine! I've used both an Amaco machine and a Darice machine for years and was just too damn cheap to spend money on anything better. Shame on me :( I should have gotten this machine years ago. I would have saved myself a lot of curses, tears and complaints. The non-stick rollers are fantastic, the clay glides through and comes out smooth as silk. The markings are clear and light to read…

So I haven't even used it yet and I'm already pissed. First, the bottom edge of this machine is VERY sharp * Check out my video of me slightly cutting through the plastic packaging it came in. Second, the handle is such that you cannot use the machine unless you hang the end of the handle over the edge of the work surface. The pen rests on the table unless you hang it over the edge of the table. Third, the clip that comes with the kit doesn't press against my desk because it has an odd angle…