Maverick Noise Reduction Adrenaline Cycles Review

Overall installation was easy. The longer drill bit and extension make it easier to drill front block holes due to the grip of the surface you are drilling on. boss recommends.

This kit is actually pretty good. I would give 5 stars if the grille had some sort of padding, but it fits fine even without it. Easy to install and definitely helps reduce that annoying squeak from those couplers. The noise is still there, but not as loud and not as shrill.

It definitely affects the noise reduction of the clutches! I was very hesitant to buy as I feel it is definitely overpriced. It should be more like 30-50.00 instead of 80.00 for 2 pieces of plastic, clips, screws and a piece of packing foam but they put research and development into the manufacturing so I can't blow them away based on the receipt that has arrived! Definitely a must if you have an X3 and want to reduce the noise!

I specifically bought the kit from Adrenaline Cycle because I didn't want a cheap Chinese fake. The cell part is really good. I cut the template almost exactly and ended up leaving about 1/8 inch on all sides. Lots of extra cuts and loops/loops. Also, I only have 4 screws and rubber caps instead of 6. Hopefully this will reduce the noise as advertised, but I've seen videos proving this isn't the case. I will update later.

$75 for some plastic pieces and a strip of styrofoam. It should be a $20 kit, I do all the hard work installing the TGE! Having ridden without this deal and ridden again after installing it, I would never spend $70 on it. No kidding, go and put the money on earbuds and you'll be a lot happier! To update! As I said, it's too expensive. I ordered another set here, another seller turned up today, THE EXACT SAME SET FOR 40 LESS BASS! Revain link below, save money. Air Intake Relocation Kit Noise…