📻 Metra Electronics 95-8245CHG Glossy Charcoal Double DIN Dash Kit for 2014+ Toyota Corolla Review

it fits my 2016 corolla perfectly and harmonizes with other parts of the car. Without looking closely I can't tell this case apart from the original glossy finish

Usado en un corolla 2015, Encajo perfecto, use fabric clips and protect the plastic clips by including them in the kit, I have to protect them from metal

I was told it would fit my '09 crown but it doesn't. I replace the factory device with a 7' double DIN. The side mounts were clunky and didn't fit. Also, I wasn't sure what to do with the incoming clips and there were no instructions. Overall the purchase and return process was easy and quick.

This fits absolutely perfectly and has the exact same finish as the surrounding dash. The mounting brackets included in this kit are not required and I do not recommend using them. The Toyota factory radio is already a 2-DIN unit with a custom face, so the factory mounting brackets work fine and are better quality than these.

Negative 3 stars is the actual number of stars I give to this product. The first issue is the mounting brackets which the instructions say you attach to it using the screws that come with the deck attach to the doubledin itself and the screws that come with most decks are around 3mm long and too short to use them -1 Had to use 10-24 x1/2" screws from Lowe's for $4, which isn't much but still got me distracted from this setup -2 The screws they provide for attaching tab faceplate,cannot be…

The photo is a bit misleading as it appears to replace the entire dash area around the radio including where the hazard warning button and passenger airbag indicators are located. But it actually replaces the area right around the factory radio, which is exactly what you want. While not specifically stated, this works on a 2016 Corolla LE (and probably all other 2016 Corolla models). The instructions are good and it matched the existing dashboard absolutely perfectly. There is no way it can be…

All in all a good kit and matches the piano finish color of the dashboard perfectly. The only complaints I have are: 1. There are four "extensions" that are part of the bezel and are used to attach the bezel to the dash. Two of these are molded along with the bezel, but for some reason you have to screw in two of them. I don't know why Metra couldn't cast all four as part of the bezel. This makes installation a bit more difficult as the extensions are a bit tricky to screw into the faceplate…