🔌 MG Electronics MGT2420 Transformer: Reliable and Approved Review

Need an extra cable to power your Honeywell thermostat? Well, the solution is there. There is no need to pull the cable to the boiler. Simply connect the 2-port thermostat cable to this unit. Then 2 more to the correct terminals on the thermostat (not to the same terminal). And plug in! YouTube tells you where to place the wires on the thermostat. I don't want to tell you, and you put the wires in the wrong place, and then there was a problem.

Heat only 2 wire boiler installations for Ecobi thermostatsThis article applies to ecobi3, ecobee3 lite and ecobee4https : //support.ecobee.com/hc/en-us/articles/227874667-Heat-only-2-wire-boiler-ofen-installationsEcobee thermostats require wire C (common) to power up. You only have two wires on your current thermostat, multiple installation options are available depending on your application.

I used this transformer to generate "normal" 24 VAC for my new smart thermostat Ecobee3 Lite. I have just installed a new Peerless water heater and the hydrostat used did not have the usual low voltage connections. It had the standard 2x T-connectors for the thermostat. I ran a new 18-5 wire from the thermostat to the boiler and used 2 for R and W to connect to T and T on the hydrostat. I added a GFCI female connector to the switch to connect this "MG Electronics 24VAC Transformer" to power my…