🔦 Enhance Rear Visibility with MICTUNING LED Light Bar Wiring Harness featuring 40Amp Relay Fuse and Blue ON-OFF Rocker Switch Review

Switch doesn't work properly I bought back the switch and 16 brackets and was eventually able to install it, but the switch doesn't work properly, it's very sensitive and it happens without touching it

They work well to keep the wires tidy and allow for faster and easier installation of auxiliary lights with a switch for my truck. For the price, this is almost as expensive as making it yourself with a lot less effort.

I love this product. I used to have to make my own suspension and I spent time doing it. This product is well made and done right! If you need to add additional electrical accessories to the side of the Side X, use them and make your life easier. Suitable for light bars, cargo taillights, even CVT clutch vents. Wherever you need power.

Not a bad deal considering what you get. The rocker switch alone costs $8-10. However, I'd be happy to pay a few bucks more for the wires that connect to the light and they would be a lot longer - this is for a "taillight" setup, so of course you'll have to run the wires from the battery from the front in the back of the car. I need to connect to the existing wiring to add at least 6 to 8 additional circuit boards.

Too much wire! I had to trim it, but it's better than missing. The fuse and relay work great and I don't have to worry about the breaker blowing. You have two LEDs in the switch. One lights up when the switch is activated, the icon is lit, and the other lights up the lettering on the switch and is either on all the time or when you turn on the light - depending on how it's connected.

Reliable wiring, good design and strong fuse to protect. I bought two of these and used them with no errors. Installed easily and securely. I connected and added additional wires to the positive and negative wiring without incident. . . I used one set for 2 7" yellow LED lights and another set for the under bumper taillights. . . Will buy again for another set of lights that I will install.

I am very disappointed in the schematic and instructions. My backlight wiring harness has red, black, white, and blue wires depending on which part of the loom you are looking at. The diagram says nothing about the blue wire. Although the schematic is black to black, red to red and no mention of a blue wire to a switch etc. The fine print on the internet says that odd colored wires are connected together. When connected according to the scheme, the switch LED is constantly lit, which constantly

Switches and relays are great. Works flawlessly. The wire that goes from the relay to the headlight. Very cheap wire. I plugged it in and started the light bar. 20" light bar. I hooked it up before doing the final install and running the wires through the firewall and those 2 white and black wires only got hot after sitting on my garage floor for about 5 minutes. Melted and almost caught fire before I could press the toggle switch to turn off the relay. I wasn't expecting a perfect high voltage

2008 Toyota Tacoma TRD Off-Road Access Cab - I used this wiring harness to connect two (2) 18w LED lights to the rear bumper. Changes: - The wiring harness was not long enough to get from the back of the truck to the engine bay. So I had to connect an extra 15ft of wire to the relay (red), light (white), and relay (black). I didn't like the fork terminal connectors that came with it, so I cut and wired new connectors. The wiring from the relay to the battery and switches was not protected and…