🔌 Monoprice 107015 Low Voltage Triple-Gang Mounting Bracket (Discontinued) in Black Review

Used with DataComm electronics 45-0002-WH 2-Way Recessed Low Voltage Wiring Plate to hide TV wall wiring. Attention: plastic. Be careful not to damage it during installation.

Well made and good price. I give it 4* because it doesn't come with a template or instructions for cutting drywall. For example, the Carlon mounts available in HD/Lowes are marked where drywall needs to be cut, simplifying the process. I had to measure and then bend to cut the drywall properly.

The plastic is a bit thinner and cheaper than I expected but should work. I will try to use them instead of my old work boxes to install satellite speakers from them. If they are too flimsy I can still use the old work boxes because the hole you need for this is a bit smaller than what you need for the old work boxes. I read another review from someone who did the same so I decided to give it a try.

Very easy to install and works great with the 12 hole Keystone wall panels I use. Just a note, you should probably trim the drywall a bit around the perimeter, stripping away the paint and scraping off some paper if needed so it's slightly recessed and flush with the wall. I also had to trim off those little bumps on the sides so the wall panel would fit in completely.

I needed a 4 way low voltage wallplate to route my home theater speaker wiring in the wall. It was easy to install and the cams do an excellent job of holding the panel to the wall without otherwise deforming the panel. The location of the screws for the bezel were also positioned correctly, which I found to be an issue with several wall panels from other companies. This will definitely get the job done, but remember this is for LOW VOLTAGE wire only.

I ended up buying from the local Lowe store to get the right size. The flange at the top and bottom of what I ordered wasn't enough to attach it to the hole and ultimately the wall termination plate. Shouldn't have gone back so I just threw it away. Lowe's, a standard off-the-shelf item from the electronics department, was perfect. I buy a huge amount from Revain, they are amazing. Sometimes you just can't tell from the seller's picture.

I've used dozens of these low voltage mounts to connect coax, Cat6, HDMI, speakers and a variety of other keystone connectors. I always use Monoprice 1-3 brackets and have never had a problem. They work well in almost every situation. Even if you're only an inch away from the stud, you can use them because you can position the plastic tabs that hold the pressure on the back of the drywall while it's being screwed. The hardest part is cutting out the drywall (I use a utility). Knife)…

As a former electrical contractor I have used these and other low voltage products since their inception. They are easy to use and adding any type of low voltage connectors and Dacora covers is a breeze and the end result looks very neat. I set up my surround sound system with different jacks (for different speaker locations) and run the cables into an open space in the wall and run the cables in the attic. I hang the wire on hooks so they don't get in the way. If you wall mount your TV, the…