🔌 Mopar 5179988AB License Plate Lamp Wiring: Ensuring Proper Illumination and Compliance Review

Correct part and working properly. The only thing was that the rubber gasket was too thick to fit in the connector. So I just used a gasket from the only one and it fitted perfectly. So far, so good.

My license plate light no longer works. Upon closer inspection, the electrical connector attached to my flashlight was completely corroded. I bought them and they lit up straight away and my light came back on. Good product.

Good replacement part. I checked out all the local dealerships and that's where he was. I had to replace both headlights which took 5 minutes, comes with a rubber cover and wiring harness. My old flashlight fell out because the rubber just fell apart.

I ordered LEDs for it. I had to stretch it hard because. The old fixtures were worn out, but they work great here, no problem. LEDs are much brighter than traditional incandescent bulbs and are almost used for backlighting. Lol just kidding they are not that bright

This is exactly what I needed for my truck, you get the whole kit, pigtail, wire, connector where you put the bulb. I also got my lamps here, the only thing I had to do was take out the old ones and put in the new ones. The job took 10 minutes because everything I needed was there.

It arrived promptly and was exactly what I needed! I had an oil change and when they checked all the lightbulbs they told me my license plate lightbulb was burned out and there would be a $70 fine if I was pulled over. Turns out I needed the entire wiring system, not just the lightbulb. The Dodge dealer in town didn't have it and it would have taken longer to get it - at a much higher price than what I got here. THANK YOU SO MUCH!