🚗 Mophorn Pneumatic Jack 3 Ton Triple Bag Air Jack - Efficient Fast Lifting Action, Maximum 6600LBS Capacity - Boosted Lifting Height - Ideal for Automotive Use (3 Tons Triple Bag) Review

I bought this for truck work and as an attachment when using my regular 3 ton hydraulic jack. For big cars, this thing works great! With my hydraulic jack, I would have to get my feet off the ground to grab a handle to lift it off the center of the axle, this also raises the truck. There are two negatives, but both are minor: they're cheap screws that come with the kit (they're removable) and they twitch a bit. But I would recommend these trucks and big cars, small cars would be more difficult…

Less than 100psi in my 6 gallon tank with the compressor off and I was able to raise the car to the maximum jack height and lower it twice and then halfway back before the tank burst. from the air. The car used for this test was a fairly new Camaro, and it simply raised the front end, which lifted both front tires off the ground at the same time. In addition, its low profile fits most vehicles with body kits or lowering kits installed. In both cases it takes less than 3-5 seconds to reach the…

CHECK ALL NUTS AND BOLT ON THIS PRODUCT AND ENSURE THEY ARE TIGHTENED! I would never go under a car just to jack it up, but still, your life may depend on checking everything when you buy it. I bought 2 bags and 3 bags. Half of the screws were loose on both and 2 bags were missing a screw securing the bag assembly to the bottom panel. Another small note: on package 2 there was the same sticker as on package 3. It is wrongly written that the lifting capacity is 3 tons. 2 bags with a capacity of…

Okay so I'll say I'm mostly happy with it. That being said, I had to make some changes to make it this way. Firstly when you put this under the axle you have to have your head and body under the car to operate the air valve. That's a bit confusing. I put a secondary valve on an extended line so I can add air without being under the car. You can use the jack to close the primary valve to ensure it is holding air. Secondly, as already mentioned, almost EVERY screw is loosened. One might think…

Harbor Freight's garbage management is getting too easy and you want a new challenge? Maybe you even try your hand at product development? Want to make sure you're NEVER tempted to just trust the jack instead of using stands? Do you have a family member in the military and want to show them what junk China makes so they know never to fear the Chinese military? If yes. this is the product for you! Out of the box, this product is pure rubbish. There were NO instructions, although assembly was…