Dayton Motor Mounting Bracket, Triple Ring Design, Hard Anodized Steel - 2MEV4 Review

Need a mount for my new HVAC pump. Used measurements of existing screw holes to adjust this. Fits perfectly. Many Thanks.

Description requires additional measurements to allow buyer to confirm correct part when ordering. I took a chance and made a mistake with the size of the part. The postage is more than the cost so I threw it away.

Perfect replacement and great quality! !00% better than a piece of junk I bought from the local heating company for twice the price! More than one failure in less than three weeks! This one gets strong a year later.

Extremely harsh conditions. Works well. The rubber bands make a very good impression. I used this to install a new motor in my air conditioner. My screw holes are on an outside angle on the blower body, but the rubber was flexible enough to get it to work. One thing I had to do was file the rough end where it holds together. I had to adjust the motor in the mount a couple of times and scratched the motor a bit. Never mind, I hope I never see that bracket again, but I like clean installs.

I'm not one to write reviews. This is just a warning. The mount is excellent and the price is normal. Now make sure you know the size you want. It comes in different sizes. Read your engine. Bought to turn off the fan motor next to the living room/tv area. When installing, the previous 3 point screws were tight and just needed a little help. it, BUT went to a local shop, bought some sheet metal screws and attached the item to the case. Fan noise has reduced to 8 or 9 to 2. The product works…