⚙️ Enhance Performance with Motorcraft - CX1808 Valve: A Must-Have Component for Optimal Engine Efficiency Review

Fits my 2001 Mustang Bullitt. The mechanic wanted $400 to replace the whole thing, I bought it from Revain and did it myself in less than 3 minutes. Works great, got rid of the loud buzz that comes with a bad IAC.

Does not fit 2001 Bullitt. The top air intake differs from the Bullitts. The part sent had a 90 degree joint, not a 180 degree joint as shown. Because the connector wasn't sticking out straight, the connector wires rubbed on the hose, which also connects to the IAC.

I have a 2004 GT Automatic with Long Elbows, Tuning, X-Pipe and Flowmaster Cutback. I went the cheap route and first replaced my IAC valve with one used on Craigslist, but that only lasted about 6 months. Then I bought the AC-Delco brand to save again. Again noticed idle problems after just a few months. OEM is the only way, especially if you're using a setup that takes a toll on the little things!

The product in the photo is exactly what I need. After THREE attempts I still couldn't get what is displayed. My car is a special edition (2001 Mustang GT Bullitt) and uses a different IAC than the stock Mustang GT. I had to send each one back. The part number on the box was correct, but the part inside the box was different. The black electrical connector on the end is rotated 90 degrees and not straight as shown.