Motorcycle Eliminator License YZF R25 2015 2019 Review

I ran into a problem trying to install turn signals on my Yamaha MT03 with this fender puller. See image. May fit aftermarket turn signals but not those that came with the bike.

The best Eliminator for the price. It's not the cleanest of setups, but I used all my factory bulbs and connectors and didn't have to splice anything. Just keep your wires nice and tidy and keep tape around to make your outside wires more secure and you're done! Easy installation and worth the money!

Pretty drowned with it. Installation was nice and easy, took maybe around 45 minutes (without following the instructions). I'm looking for a new license plate and turn signals. The standard panel backlight is a bit cramped and I think it would look much better with a smaller blinker. But as for the trowel, I can't say anything bad about it. Looks much better than stock.

The aluminum had to be cleaned before painting, large scratches are visible through the black paintwork. Most of the mount isn't visible so now that it's in place the finish isn't much of an issue and the visible area looks good. The function is fine and keeps the backlight. I attached the end of the original fender with some rivets, leaving a fender to protect the tail light. That looks great.

Received this today and have already fitted it to my new 2019 R3, it was pretty easy to install! And for the price it can't be beat. It looks amazing and is just like those $100 cock cleaning kits out there! All standard headlights will fit fine, when installing swivel singles the shims from the kit must be fitted from the back and larger to smaller, if the shims are not placed exactly right they will not work properly! I give 5⭐️, great price, great looks, easy installation👊👊

The name clearly says it will fit the mt03 through 2021, but the holes are too small and the wiring itself doesn't even go through. If you're selling an item to keep these details, you should probably test them first so you really know for sure. Do not buy this product. A complete waste of time and money and now I have to pack my entire rear fender to drive home. You'll have to drill holes tomorrow to make it work because you're too incompetent to test it. GARBAGE.

Fast delivery and easy installation. Read the reviews before installing. YouTube also helped a lot with the installation. When installing the lights, I noticed that they dangle a bit, as others have said. I took the large washers that came with the kit and put them on the outside of the headlights. I then threaded it through the holes and put a medium to small washer before attaching the screws. He really held on. I'm not worried about it falling off later. It's pretty safe. As a racer, I agree

Easy to install. I saw TSTINDUSTRIES how to make videos and follow the same process. I removed the stock turn signals and license plate lights from the stock fender and installed them on a rectifier. As one reviewer said, the drawing light is really tight. Now, as for the turn signals, they fit, but not tight. They talk a little. I followed one of the reviewers who talked about large shims down to the smallest but forgot to add lock washers and that's probably why they're hanging around. After…