🏍️ Premium Motorcycle Floorboard Foot Pegs for Honda Magna VF250/VT250/VF750 and Yamaha V-STAR DragStar XVS 650/Virago XV125/250/400 - Front/Rear Passenger Pair (1994-2013) Review

Not suitable for vstar 1100 declared. Cheap, inferior metal. I mentioned that they might have the worst welds I've ever seen. They were by no means safe or worthy of the road. Too bad I didn't scratch them when checking out the installation, otherwise I would have returned them instead of throwing them away.

This part was not easy to install. I have a Honda Shadow 750. One side needs to be shaved off about half an inch. On the other hand lots of wd40 and a big mallot, finally got it only to have it removed because the other one wasn't seated properly. Simply order from the dealer. As time passed, money and now a reprieve to ride. Just not worth the trouble

I bought the front and back floorboards, the back ones were $48 and a cent, the front ones were $47 and a cent, the problem I got was the front and back boards, damn that Same, the back planks tend to be smaller than the front ones, I don't know if my clients will like them or not

Footrests WILL NOT FIT standard bike slots although they claim to match. So I found matching square pins (void warranty or return) and found that the pre-drilled holes were nowhere near. It's pretty hard to appreciate the convenience when I can't even install the product. I tried to contact the company. , never heard from again. It will be interesting to see if I get my money back in full now that I had to switch sides. Garbage!

NOT AT ALL SECURE! They will break and kill you. Cheap soft metal. The head of the pen was not round. The Board of Directors will not respond to this. There are cracks in the weld of the circuit board. It's garbage. Spend your money and buy well-known brands of floorboards. That's half the cost of a big brand because it's junk. You'll set off when you least expect it and meet drivers behind you. This is an accident waiting in the wings.

It says it fits my Honda Magna VF750. It is not. I had to sharpen the insert a little to make it fit. Once that was done they were on, but with the default pause it got in the way and didn't allow my brake light to turn on as the wiring had to be done. Also, my shifter had to be raised a lot to fit my boot underneath. It just doesn't work on my bike. If these boards were a little shorter they would be amazing. I wish I could use them. I had to take her off the bike.

Good size. Perfect for '00 XVS1100A (YAMAHA Vstar 1100 classic). Had to grind the end of the pin 1/8" to fit (no problem). I painted the underside of them to bless the ride up. I also replaced the pins with 7mm hex head screws and tightened so there is enough tension to keep them folded I weigh 180 pounds I stood and jumped on them and they didn't bend Welds are good, good penetration (anyone can make a "nice weld" but none Penetration. Use call welders. This is the final weld. Take a grinder…