👃 100PCS Adhesive Metal Nose Bridge Strips for Face Mask - Mr Rex, 90MM Aluminum Flat Nose Wire with Backing Tape, Bendable Sticky Nose Pieces for Mask Sewing Handmade DIY Crafting Review

I bought these for my colleague. She wears glasses and we have to wear masks. Her glasses ALWAYS fogged up every time she spoke and it was obvious that she was annoyed by that. So I saved them for her and they worked like a charm. She's stopped complaining about fogged lenses and I can see they're working because I don't see them fogging up every time she speaks. Happy about everything.

They are so easy to fit onto masks that don't have a metal nosepiece. I took off the tape, placed it on my back at the very top where your nose should have been, put the mask on and folded it to fit my nose. Then I put on my glasses to see the fogging and I had next to nothing. A little at the bottom of my glasses, then I tightened the bar, now nothing. Must be!

If there's one thing I learned from my dad who was an engineer, never cut corners and save money. It s cheap. They kinda worked, but they didn't tighten the mask the way I wanted and didn't fit my nose very well. Adding a second one made it worse and after 2 days the tip came off. I haven't even used it that long, only 2 hours and haven't had a chance to wash it. Maybe I had a bad batch but they are not very good. If you need something temporary, $6 was a bit much for this quality. The metal…

The very first item I took out of the box was cut wrong, see picture. It has sharp edges and I don't want the tip near my eyes. I bet I could cut ham with it. I can't remove the sticker from the back to test the adhesive so I'll probably have to either sew the pocket on or try to pin it into the top seam. It folds up VERY easily; Once it forms on the face, it doesn't take much movement to loosen it. I thought it would be a little harder. UPDATE: I did a bend test by repeatedly bending it back…