🏍️ Nelson Rigg DC-505-03-LG Grey Indoor Motorcycle Dust Cover, Large Size - 1 Pack Review

Large size hardly fits my Yamaha R3. It feels very cheap, flimsy material, I'm sure it won't even last a year. It also doesn't have multiple sections to conform to the contour of the bike as shown in the photo, it's more like a plastic bag with a seam so the corners stick out when you put it on the bike. The only plus is that it's cheap. I will replace it with something else as soon as it breaks.

The X-Large is perfect for my Yamaha Raider. The bike is long without panniers, but I think it would still fit if it had panniers. Please remember that this is an indoor dust cover, it is not waterproof or waterproof. The product is very easy to put on and take off in a few seconds and protects the bike from dust. I also have a Harley Road King with a windshield and wide hard cases and the XX-Large fits perfectly. It doesn't have the stretchy bottom that outdoor covers have, making it very easy

2012 Heritage Classic. This cover is easy to install on my scooter. It hangs on the floor around the perimeter. I have a clamshell trunk in the back that also fits. What I like best is that you just have to grab it when you want to access the front of the scooter. onto the fender and lift it up and back. The same with the back. This is exactly what I was looking for. Neat cover. No rubber band. Put it on the same way you put sheets on a bed. Lift it up, pump in some air and let it sink onto the

I bought a DC-505 XL motorcycle dust cover. I just wanted it for my garage so it's perfect. It is intended for indoor use only, not as a rain cover, just for dust. It's lightweight and fits perfectly on my 2016 Street Glide. I can poke a hole in where the antenna is, as I saw on the internet the guy did it and then sewed it around so it wouldn't tear, but it's not necessary for my bike as there's plenty of room for the antenna there . under the lid. I am very happy with this product and would…

I bought an XL for my Harley Dyna Low Rider S to keep the dust out of the garage and it turned out to be too big. I ordered a large drawing which would be a good compromise. It was too little. My bike is 96 inches from tip to tail. The large cap is 86" and the XL was about 102-104", I don't remember if I measured it. Nelson-Rigg doesn't publish the sizes of this cover for some reason, only L, XL, XXL. Anyway, the point is the Large is back and I'm leaving the XL simply because it covers the…