🔧 Neoteck Auto Ranging Digital Multimeter - Portable Case, 4000 Counts Volt Meter for AC/DC Volt Current Resistance Capacitance, Frequency, Temperature, CMOS TTL Duty Cycle, Transistor Diode Review

Works well, easy to use, provides all required electrical parameters with good accuracy. Very happy with the purchase so far.

I love Neoteck's Auto Ranging DMM capabilities. I've been looking for a replacement for my old multimeter that was stolen for a while, sometimes old stuff is better done. I feel this device meets my needs and is in a better price range than before. about 3 times less with about the same properties.

I know the meter wasn't of the highest quality, but it's not even worth the price. I've used this meter twice in the 2 months I've had it and it shows a different resistance of up to 1.5 ohms just by touching the wires. I have an old set that fixes the problem but if they can't give you decent results then I can't trust the readings either. It's too late to return it, otherwise I would have done it.

Looks like a great low cost multimeter! The included cables and thermocouple are good. The case/case is cheap and offers little to no protection, but it's nice to hold cables and vehicles inside. It seems impossible to convert TC readings to degrees Fahrenheit, but this is not uncommon for inexpensive meters. For my purposes (heavy homeowner) this is a good tool.

Large counter. This is my second. The second accidentally left in the country. The price and quality made it worth buying another one. I've been using the original meter regularly for over a year. No problem. Easy to use. Easy to read. The auto power off feature saves battery power if you occasionally forget to turn it off. hard case. All the features I need. Fair price. I definitely recommend it.

Not sure if this is common with this meter but all batteries have already been installed. This caused some oxidation that had to be removed before the gauge would work. After a brief flush, the gauge was functional and within the expected error range of the other gauge. I'm a little concerned that the oxidation may come back, time will tell. All in all a decent meter for the price, just a shame the batteries weren't pre-installed.

So far so good. I have used more functions but have not tried CMOS, TTL or ammeter. The voltage works well, both DC and AC. The ohmmeter, continuity, diode, frequency counter and capacitance meter are fine, but the latter can have a 10 second delay, but that's for sure. The temperature is ok, although I've only used it once with boiling water and it was wrong. The hfe functions operate at 10uA in the base, so care should be taken with this measure. I use more hfe to see if some LEDs work…

Seems ok to me, pretty good actually. I love the Auto Range, which I didn't think was possible before buying it. Inserting the transistor into the holes for HFE measurement was difficult from the start, but I managed it. However, this feature is not that good. It's hard to find the little holes at the bottom of the holes where the transistor leads go. Also, I may need to hold down the transistor to make firm contact to get a reading. However, other counters on the market look just like them. I…