💯 Enhanced Efficiency Nozzle and Venturi Assembly 7187065: The Ultimate Solution for Optimal Performance Review

This part was exactly the same as mine so it fitted correctly. However, I have asked both here at Revain and on the manufacturer's website to make sure it is the right part for my water softener before ordering and neither the seller nor the manufacturer have had the decency to answer me. Also note that this does not come with O-rings to attach to your device. If you are unsure if your rings are good I recommend buying new ones so you don't have a leak. . This block didn't solve my problem, but

This kit fits different brands of fabric softener. In my case it was Northstar NSCA39UD. Much easier than just replacing the bezel and screen. Note: I removed one star because the two small neoprene o-rings are not included. They need to be migrated from the old site. Replacing the existing assembly took less than 5 minutes according to the parts diagram at the end of the manual. Make sure your water supply is shut off or at least on the bypass in case something goes wrong. Then simply unscrew…

The sucker died after approx. 2.5 years. This replacement fixed the problem. This pulls the brine solution through the deionization resin to restore its function. The water stays in the tank and forms a salt bridge that is difficult to break through. Watch the water level in the pipe during the brine phase, it should drop almost to the bottom. See manual for manual transition to brine step. If the water level does not drop noticeably within 15 minutes, it is defective. It looks like the seal is