🚙 OEDRO Front Bumper Combo for Jeep Wrangler JK & Unlimited (07-18) with Winch Plate Mounting, D-Rings, and Upgraded Textured Black Rock Crawler Off-Road Star Guardian Design Review

Bought for a 2015 Unlimited 4dr Sport Jeep. Installation problem 1. It was necessary to cut holes for the screws. on original fog lights where not in the right place, the offset is adjusted to 1 inch. Problem 3 - no customer service after 7 calls, no answer, left voice messages and that's it. Looked great on the jeep, just sucks.

Owners from 3 months. Very disappointing. Rust film everywhere, especially on some welds. I'll take it out and fix or replace it in the spring. Update: The OEDRO seller was very helpful and offered me a refund due to the rusting situation. While I would not purchase this particular bumper again, I would have no hesitation in ordering a different product from ORO.

Nice little bumper. Ease of installation. The hardest part was removing the factory bumper. The original fog lights fit into the new bumper. You just have to extend the wiring a bit to get there. No splicing, just peel off some tape to extend the excess in the lid. It's easy for someone like me who doesn't know anything about car work. I haven't installed any LED cube lights yet. The headlights were missing 2 of the 4 lock washers and the electrical wires coming from the headlights looked like…

This bumper looks fantastic and gives the Jeep a much more aggressive look. Since the bumper was attached with only 8 screws, it was quick and easy. Although it comes with two small LED lights, I have yet to install them as I will likely install a full 16-18 inch LED panel instead. It should be noted that the bumper is supplied without a license plate holder. I would like to install a winch at some point, I have decided on a license plate mount that folds out to allow access. The problem is…