Omix Ada 17206 04 Speedometer Assembly Review

The temp gauge starts off right and then slowly drops to about a quarter of a tank. I also have an Omix fuel pump. After 200 km the temperature sensor stopped working and got stuck at the maximum. I called Omics and they will replace him but they said. "We will test the new test bench to prove that the sensor is not the problem. headlight. If I could give 0 stars I would. I kick myself for getting rid of the factory block

I wanted to "go old school" and do a flat dash system on my 87 YJ. I bought this build thinking it would be a good start. The reasons I only gave it 4 stars were 1. It has a plastic front panel not glass which gets scratched fairly easily I'm sure. 2. The ohm fuel gauge is the exact opposite of my transmitter unit in my tank. So when I have a full tank it reads empty and when I'm empty it reads full. Another downside was that it didn't have any lighting or bulb holders on the back and they were

The sensor looks identical to the factory sensor. Temperature sensor not working, tethered like most other reviews say. (Should have read a little more carefully.) The fuel gauge seems to work fine. It is divided into quarter, half, three quarter and full. My original was just empty, half and full. It bit me once, I misread the ad and thought I had a quarter tank left and ran out of me. (Lesson learned) The actual sensor jumps, but I'm not sure if it's not the cable that's causing some of my…

This instrument cluster (speedometer, fuel, temp) is rubbish. The only reason it got one star is because I can't give 0 stars. The notch on the dial is rotated about 5 degrees to the right, making the entire gauge look like an idiot installed it on the dash and wasn't aligned properly, since this gauge is four-corner supported and not mounted like the other gauges. , this is a manufacturing defect. Of course I could take it all apart and reassemble it properly, and I probably will. but what a…