ORANDESIGNE Rubbermaid Kerosene Occupational Health & Safety Replacement Gaskets Review

The rubber seal is too big for an "easy" seal when the spout in the gas cylinder is protected. Makes it a bit difficult to screw the lid on properly. Slight irritation. The same seal works great in a pot configuration. Way better than any other poorly designed junk on the market. I've tried several. Because it works so well, I buy more to replace the impossible, ridiculous, stupid, dumb, dangerous "government" designed spouts on my other cans.

These six packs arrived on time. Basic instructions can be found on Revain's description/order page under the Product Description section (scroll down the page). They go perfectly with my Blitz™ cans. However, as suggested, I cut out two holes for the hinges so they can be screwed in nice and tight. With the Zepter™ jars, I just used the existing screw caps. They are raised directly onto new spouts. First I made sure the jars were empty and dry to install the vents. As suggested I used a set of

Failed to load media. So this is a great replacement for gas bottle spouts. The details are well done. People complained that the quality was rubbish. It's not like this. The spout was curved but nice and sturdy to make them go back to their original shape. The o-ring around the base was pliable and held up well. The base of the spout is exactly the same size as the old "safety" nozzle I replaced it with. I put one of these on a Blitz container, one on a Midwest container, and one on a TSG…