OTUAYAUTO Rear Windshield Wiper Blades Review

Less than a year later both wipers were burnt out. Something in the design is deformed or broken as only the underside of the wiper blades remain in contact with the glass. The lower part wears away and begins to shatter before the upper part makes constant contact with the glass. My mistake is to only buy by price.

Very BAD quality product does not wipe the rear window of my Toyota Matrix, it is like giving a half wipe instead of a full wipe like my old original Toyota rear wiper gives, unfortunately I am sending this product back to amazon for a refund. I'm just NOT a happy buyer of this cheap, crappy product from China!

Although they are easy to install once you know how. However, they don't fit the rear window of my car (Prius) and only clean half the window. works, i tried bending it a bit still didn't work so i replaced it with a second block. Same problem. When I did all this, the return window was closed. So now I have a half back view.

This is a great value for me, especially since I live in a city where you can't just drive to the next town and have an 11 inch wiper from another car part. After I installed the wiper, it was pushed down a bit so it wasn't floating free or touching the top of the 2 inch top end of the blade. I took it off and scraped some plastic from the inside of the new wiper where it slides over the wiper arm. I also put a few drops of silicone grease on the connection points. Now it works as it should…

These wipers for the rear of our Toyota Prius seem like a great deal. Of course, time will tell if they will hold up or if the rubber is reliable. They arrived on time, clicked quickly and fit like a glove. I like the no-name brand's closed-frame design compared to some open-frame brand models that cost more than double at local auto parts stores. With the winter compound we have in our area, ice often forms in the open frames of more expensive windshield wipers, rendering them useless unless…

Replacement wiper connector is longer to avoid arm clip snagging. The new blade rests against the arm mount but will not snap into place because the hole in the blade is too large. The pressure of the spring arm can push the blade against the glass, but I'll have to see if it falls off when the wiper starts to move. If the hole was 1/16 or 1/8 inch smaller the latch would work. If it doesn't fall I would give 4 stars due to the loose tolerances. If it falls on the highway in the rain it will…