Header banner
Revain logoHome Page
πŸ”˜ 14 20 inch pack of circular plastic plugs logo

πŸ”˜ 14 20 Inch Pack of Circular Plastic Plugs Review

3

Β·

Average

Revainrating 3 out of 5Β Β 
RatingΒ 
3.0
βš™οΈ Biscuits & Plugs, πŸ”© Industrial Hardware

View on AmazonView on Π―M

Media

(3)
img 1 attached to πŸ”˜ 14 20 Inch Pack of Circular Plastic Plugs
img 2 attached to πŸ”˜ 14 20 Inch Pack of Circular Plastic Plugs
img 3 attached to πŸ”˜ 14 20 Inch Pack of Circular Plastic Plugs

Description of πŸ”˜ 14 20 Inch Pack of Circular Plastic Plugs

Please note that the size in the listing is for the OUTSIDE dimension of the tube. The hole dimension range is from 1.21" to 1.30" only. Please check the tube hole dimension and verify before ordering. These are good for Tube hole ID 1.21" to 1.30" only. Check your tune hole ID before ordering. Suitable for: 14-20 Ga - 1.21" to 1.30" ID.

Reviews

Global ratings 3
  • 5
    2
  • 4
    0
  • 3
    0
  • 2
    0
  • 1
    1

Type of review

Revainrating 1 out of 5

Disappointing Round Plastic Plugs in Industrial Hardware

Based on my observations, these plastic plugs are made of low-quality material which easily breaks apart during installation. The size measurement is also confusing, making it difficult to select the right size for the job. While the affordable price may seem attractive, the subpar quality makes it a waste of money in the long run.

Pros
  • Affordable price
Cons
  • Poor quality, confusing size measurement

Revainrating 5 out of 5

They look great: Industrial Hardware

later I used this to finish off the ends of some galvanized intake pipes. It was tight but they looked great. One thing I would recommend when installing is to use a rubber mallet and hit them straight and evenly.

Pros
  • Fits 1.21" to 1.30" ID tubing only. Please check your fitting hole ID before ordering.
Cons
  • I will add

Revainrating 5 out of 5

Get this when you need to replace the end cap on your speaker stand or pole PA

I bought this to replace the end cap of a standard 1-3/8" speaker stand, but it will also fit in a speaker stand. I almost gave up trying to find one as I couldn't find any OEM replacement parts, and most of these end caps/caps are 1-3/8" ID (ID) with 1-1/2" OD. Great quality, reasonable price and perfect fit!

Pros
  • Please note the size shown is the OUTSIDE tube size. Hole sizes range from 1.21" to 1.30". Please check the pipe hole size and verify before ordering.
Cons
  • Doubtful