🏍️ Partsam 4.5" Motorcycle LED Third Brake Light Universal Tail Brake Stop Turn Signal Running Light 6SMD Super Bright Red LED Strip Light Bar Review

Factory third brake light on my 06" Hummer H3, cost between $150-$260 to replace. I bought these two strips and only needed one. I attached it to the factory LED strip and connected it to the factory power wire and ground. It took 30 minutes from start to finish!

Product arrived as advertised. After reading a review from another buyer about how they used it to replace a broken third brake light on their g35, I took a chance. I soldered the product to my old wiring to the 3rd brake light. The light spell worked. Would highly recommend to other G35 sedan owners.

Used to restore/repair a set of golf cart taillights that were no longer working. Managed to remove the original LED board from the case and attach two of these strips for the tail/brake/turn signal function. Much brighter than the original LEDs and fixed the weird voltage feedback issue with the original LED boards.

Good bright headlights but not too bright. I use them to lighten the mood in my suburb. I noticed that after an hour and a half they started to warm up, not hot just warm. Great lights were -20 at night and around 50 during the day and they still stand out. So I'm happy and will consider other uses for them and order more in the future.

I didn't use these as intended but they still worked great! I needed to replace the 3rd brake light in the lid of my truck and it fitted perfectly! The nice touch was I could trim them down if needed, which I did - I ended up using one and a half out of two and they're a lot brighter than the original halogen bulb that came before.

These LED strips are pretty good! I attached them to the back of the passenger footpegs. They worked great. I hooked them up to my braking system and they work really well with the tail light. They really help improve driver visibility. You're much more likely to see cars if they have more running and brake lights than a factory taillight.

Like other reviewers, I think I was just hoping for more. They work well, the wires are thin as mentioned, but with normal care this hasn't been a problem. Tacky glue is great. I don't use the blinker function, only the parking and brake lights. You can easily distinguish the running light from the brake light. Just not as bright as I had hoped during the day. I would have paid slightly more for something significantly brighter. Perhaps the only way to get what I was looking for was to replace…