🚦 Partsam High Mount Stop Light - Replacement for F150 2004-2008 - Waterproof Smoke Lens Black Housing - Perfect Tail Light Upgrade - Rear Cab Roof Center Brake Lamp (1 Plug) Review

Easy installation after detaching the Ford wiring harness. The LED lights are bright, but the truck lights are pointing straight back and not into the back of the truck. Very useless when trying to get something out of a truck bed in the dark. Going back to the original hardware at least I know it works in the dark.

Think I'd try them on my F150. Installation was pretty easy, you need to know what you're doing. Check YouTube if you are unsure what to do as there are no instructions for the item. In general it looks like a good quality device but the brightness of the LEDs are far from what I expected not being very bright. The factory block was much lighter than this one. Overall the purchase isn't bad, I like its looks but the functionality isn't quite there. What's nice is that the setup is fairly…

DO NOT CUT THE WIRING OR REMOVE THE COVER. I am in the process of replacing sun tanned parts on my 2006 F-150. This third brake light replacement was the first part I received and ran straight to my BIG RED truck to have it installed. After I took the old one off, I thought, crap, it doesn't fit. I have 3 plugs, in the new one. If only he were willing to return. I started reading reviews and thank goodness. how did i do it Disconnect the light from the 3 connector harness. Follow the wiring to…

This is a straight wire connector for 04-08 F150. You can install it in three ways. 1) Cut and connect. You would cut off the connector on this headlight and plug it into a three connector Ford wiring harness. This may be a good solution for some people.2. With the old light removed, look up and right into the pocket. There will be a white serrated clip with a small pin to prevent rotation. You'll have to loosen this somehow or cut the notch to release the connector, then fish it out, unplug…

Received my flashlight and found it to be quite well made. Read other reviews and wanted to add my 2 cents. The seal that comes with the headlight looks quite high quality. My fork went right into the factory fork but wouldn't snap so I used some tape. Then head to the store to buy a tube of clear RTV sealant for $2.99. Remove your old light, clean the surface where the gasket rests very well. Then, before removing the tape from the pad, lay it down and see where it lies. I had 2 small holes…