🔒 Highly Durable EZ Pass Toll Tag Holder - Resistant to Heat & Cold! Perfect Fit for Mini & Old EZ Pass, I Pass, I Zoom, PalPass Hard Case, FasTrak Transponders Review

I already have a dash cam that takes up space on my windshield and I rarely drive on toll roads so I bought this mount so I don't have to keep an eye on my transponder. . I've used it with both the old, larger transponder and the new, smaller model and it holds both perfectly and also removes easily when it's time to put it away.

I was looking for a new mount for my new smaller tag. This one seemed to have a large suction cup. However, I couldn't get the block into the holder, tried and tried. So I took some soap to make it slippery so I could score a notch, although it was still very difficult. The soap slid too much and when attaching the windshield, the label popped out of its holder on the floor within two seconds. money thrown away.

It took a little effort to get the EZ Pass (small version released in Maryland) into this clip, but once inserted it holds securely and doesn't wobble . I've only used it once - left it on my windshield for a few days - and it's held up. Since I don't need an EZ badge very often, I like being able to remove it from my windshield and store it. It's far away in my car when not needed. Due to my limited use I would recommend this product.

I bought a year ago to replace the plastic EZ Pass holder which has deformed terribly over the summer. It decayed and the suction cups failed after the same summer. After I switched to it, I had no problems with it. Holds well, after the first application did not have to be vacuumed up. It is important to ensure that your initial installation is on clean glass. I quickly wiped it down with an alcohol wipe to remove dust, dirt, and oil. I have now ordered these again for another machine and…

The product has minimal dimensions and is completely unobtrusive and above all it just works! My old plastic EZ Pass holder has melted in the sun, especially where the tiny suction cups are attached. On hot days, it kept falling out of the window due to melting plastic or failing suction cups. This solves both problems. First, it's metal! Won't melt in the sun. In addition, a large suction cup sticks to the glass much better than 4 small ones. The spring action in the arm holds the EZ Pass…

Prevents adhesive residue from sticking to windshield. Not sure how well the suction will hold up as it is sandwiched between the rearview mirror mount and the headliner. On the second machine, the suction cup is not attached to the black grooved disk near the mirror, so the transponder is held to the sun visor with silicone straps. In fact, stripes are preferable because the transponder can be flipped out of sight and closer to the preferred "A" position (BayArea Fastrak Installation…

Like one of the other reviewers, I just picked up my new car and didn't want to put those adhesive strips on the inside of the windshield. So I started looking for Revain and came across this product. My photos show that I have an E-ZPass from Massachusetts. It goes very well with this device. It took a bit of effort to slide him in, but it wasn't impossible or terrible. I didn't have to open it up or use pliers. I put it on my windshield overnight and it sat there for almost a good 12 hours…