Enhance Your Hyundai Veloster Turbo's Power with K&N Cold Air Intake Kit: 69-5312TS Model Review

The install didn't go bad, it's one of those things, if you do it a second time it will be so quick and easy to do. Since this was my first time (maybe yours too) I found that I did some steps twice because the manual didn't make it that obvious to get it right the first time. If you take your time and really think about it, you should be fine. The performance of the intake system is great! The car is much more responsive in the lower gears and I think I have more mpg in the upper gears…

Firstly, the product does what it promises. It increased my acceleration rate, improved gas mileage and it sounds so good! I'm not sure if I actually added HP, but it makes the car feel a lot better! As usual for K&N products, the product is of high quality. The intake pipe is made of polished aluminium. Thermal protection and brackets are also metal, I don't know what they are made of. The BPV system's rubber hose and heat shield liner are not cheap rubber. The only problem with this kit is…

At the time of writing, the air intake has been installed on my daily driver for a month. As long as I like it The product arrived very well packaged. Nothing was damaged and there was no styrofoam or anything that couldn't be recycled. Very good. Except for the hardware, everything was fairly well labeled. Looking at the diagram it was obvious what went where, but the first time I used the wrong length screws I had to disassemble them. **PLEASE NOTE** that the screws are available in two…