🔧 Efficient Performance Tool W41031 Engine Stand: 1,250 lbs. Capacity, 360 Degree Rotating Mount with Tray Review

Great product! I used this on a 4.8L Lincoln engine and it worked great. I had it lying around for almost 2 weeks until I swapped all the cams. There have never been any problems. Being able to spin the motor was also a great feature and very handy!

On the rotating part, it is impossible to get the pin back into position unless the motor is moved forward an inch. Some of the bolts were too short for the lock washer. So I got along without her. My box was also dented. When the postman put it on the ground, 2 pucks fell out of the box. It was bad. Next time I would spend a little more and get a higher quality stand.

On the rotating part, the pin cannot be reinserted unless the motor is moved forward an inch. Some of the bolts were too short for the lock washer. So I got along without her. My box was also dented. When the postman put it on the ground, 2 pucks fell out of the box. It was bad. Next time I would spend a little more and get a higher quality stand.

Had to buy all the missing bolts he didn't have. I guess they just throw a handful of screws in the box and get the job done. The shipping box was taped but open at both ends. The necessary attachments are loose, not in bags. After assembling it is as expected. Wouldn't buy it again. There are cheaper options. I didn't use the parts tray like I thought I would.

Yes looks cheap when delivered. The box was completely torn (UPS) and the individual parts were loosely separated by pieces of cardboard. Nuts and bolts, washers just lay at the bottom of the box, and paint was bubbling on one of the legs. But seriously, do you buy an engine stand to make it look nice? no problem. Turning the engine upside down took a lot of effort, but it's a heavy engine. Works great, has virtually no risk of tipping and slides easily across the floor. MUCH better than port…