High-Capacity Performance Tool W41037 Engine Stand with Straps - 750 lbs Load-Bearing Capacity Review

I used an engine stand to hold a Ford 300 inline 6 engine. It worked very well for this purpose. It's a very good stand for the price and I would recommend it to anyone.

This worked great on my 340 engine! I think it's easy to set the sump load for each engine! Well built, easy to roll on the cement floor!

sloppy (wouldn't have tried these self assembled products to make sure that they can actually be assembled), this would be a 5 star product. Instead, schedule a 1/2 hour custom modification session and drill four new 1/2" holes in the corner. The offset distance is almost 3/16" at each end of the crossbars, so the well-fitting 7/16" studs on the ends of the rollers cannot be aligned.

This is a very light stand and should be used with extreme caution, especially if the motor is heavy (isn't it?) and must be kept on it at all times. I was going to buy a couple of these for my various engines including inline 8 cylinder blocks but decided to test them out first by just buying one and I'm glad I did. I have an empty inline 6 cylinder block and after a few weeks the wheels started looking a bit flat on the bottom and are now difficult to roll. I'm afraid if one of the wheels…