🌧️ Protective Weather Cover for No Zip Pet Stroller - Pet Gear Special Edition Review

Goes very well with our stroller. Bought so we can take the bunny for a walk in the winter and keep him warm by blocking the wind. But it seems to work well - the rabbit likes to look out and does not freeze. The only reason I didn't give it 5 stars is because the window plastic is really crumpled which blocks the view.

I have a Pet Gear NZ AT3 Jogger in Summit Grey. I bought the poppy red cover, it's lighter than the picture. It fits perfectly. (Align back glass and the rest is easy to put on). The only reason I give it 4 stars is that there is some red paint on the clear plastic that won't peel off. I hope it doesn't bleed when it gets wet. I will wash it before use. I will update after use.

I was delighted to get this and also the stroller for my two Yorkie puppies. or other damage to the reproductive system. WHY - Pet Gear - would you release a product like this? If your stroller contains the same chemicals, rest assured you'll get BOTH back! What can you say about that? Disappointed former customer!

It's perfect, fits perfectly, loose and not too smug, but fits perfectly. It took me a few minutes to figure out how to put it on. But you just put it around the grip and the front of the bottom bracket on the base first and then put the top between the handlebars and you have to snap and remove the tray. It takes seconds to pick up or withdraw. And you can fold down the front back for ventilation, and there is also a velcro on the rear mesh under the handlebar to open the plastic cover.

I have a Pet Gear AT3; Purchased July 2015 Purchased December 2015 Pet Gear weather case. I had to read the instructions multiple times and look at the photos to fully understand how to fit. It states that some strollers require the tray to be removed. Apparently mine was one of them. After proper coverage, it sits free. This applies to nylon material; super, super thin. I'd rather have a single cover than separate sections. Tiny velcro leaves plenty of open slits for cold air to enter…

Haven't used it yet but thought it looked decent at first glance. The weather hood was easy to put on with common sense. Once you manage to find a clear vinyl "square" for the rear viewport, everything else will be intuitive. Place a piece of clear "square" vinyl between the back of the frame and the cup holder. With my at3 no zip I didn't have to remove the cup holder. The weather protection cover is made of thin nylon, but it can be done without rough work. The clear vinyl square on the back…