Header banner
Revain logoHome Page
πŸ’¨ 0-5-4-5v pressure transducer with 0-10psi transmitter logo

πŸ’¨ 0-5-4-5V Pressure Transducer with 0-10PSI Transmitter Review

3

Β·

Average

Revainrating 3 out of 5Β Β 
RatingΒ 
3.0
πŸŒ€ Pressure & Vacuum, πŸ” Test, Measure & Inspect

View on AmazonView on Π―M

Media

(4)
img 1 attached to πŸ’¨ 0-5-4-5V Pressure Transducer with 0-10PSI Transmitter
img 2 attached to πŸ’¨ 0-5-4-5V Pressure Transducer with 0-10PSI Transmitter
img 3 attached to πŸ’¨ 0-5-4-5V Pressure Transducer with 0-10PSI Transmitter
img 4 attached to πŸ’¨ 0-5-4-5V Pressure Transducer with 0-10PSI Transmitter

Description of πŸ’¨ 0-5-4-5V Pressure Transducer with 0-10PSI Transmitter

[Full voltage protection]:With stainless steel body, provides complete surge voltage protection. [Stable and reliable]:This pressure transducer adopt compensation technology and sensitive components, stable and reliable. [Widely use]:Widely used in oil tank, gas tank and diesel tank to detect oil, fuel, diesel, gas and water. [Easy to operate]:Lightweight and compact, easy to install and operate. [Note]:0.5%FS small output error, including nonlinear, hysteresis error and repeatability.

Reviews

Global ratings 3
  • 5
    0
  • 4
    0
  • 3
    3
  • 2
    0
  • 1
    0

Type of review

Revainrating 3 out of 5

Pretty linear. Two units, different ranges! The housing is not necessarily isolated from the electronics

I ordered two of them, probably the same series. There are no markings on them so I have no idea what their max pressure was. a water column to measure accuracy and an Arduino to test side by side in 50cm increments Block 1: 50cm = 50 counts. exactly after 3 m (330) unit 2: 50 cm = 30 units. Approximately 1 reading from linearity at 3 m (215). It is important for the devices to stabilize in order to achieve this linearity. I started the first sequence right after turning the device on and there

Pros
  • pressure and vacuum
Cons
  • I'll write later

Revainrating 3 out of 5

Pretty linear. Two units, different ranges! The case isn't necessarily isolated from the electronics

I've ordered two of these, presumably the same series. They don't have any markings so I don't know what their max pressure is. Accuracy and Arduino to test them side by side in 50cm increments Unit 1: 50cm = 50 counts. exactly after 3 m (330) unit 2: 50 cm = 30 units. Approximately 1 reading from linearity at 3 m (215). It is important for the devices to stabilize in order to achieve this linearity. I started the first sequence right after turning the device on and there was drift and…

Cons
  • I don't remember

Revainrating 3 out of 5

Pretty linear. Two units, different ranges! The case is not necessarily isolated from the electronics

I have ordered two of these, presumably the same series. There are no markings on them so I have no idea what their max pressure is. a water column to measure accuracy and an Arduino to test side by side in 50cm increments Block 1: 50cm = 50 counts. exactly after 3 m (330) unit 2: 50 cm = 30 units. Approximately 1 reading from linearity at 3 m (215). It is important for the devices to stabilize in order to achieve this linearity. I started the first sequence right after turning the device on…

Pros
  • Test, measure and verify
Cons
  • Crumpled packaging