💡 Connector for Pressure Transducer Sender Sensor Review

bought two of these to measure the water pressure. Installed one and it failed with a continuous 0 volt output after only a few hours of use. Check the wiring, which was fine, then replaced the faulty unit with the second one I bought. The second one still works, but it's only been a day since it was installed. Unit accuracy was not an issue. Both showed an offset error of <+/- 0.3 psi. inches without calibration. The real-time measurement values are also very close to the reference…

I designed an analog circuit to process the sensor output and was ready to hook it up for testing. NO wiring legend. There was a black, red and green wire. I was looking at two similar products on Revain which I thought were the same sensor sold by different companies. Both had wiring that made no sense. Trying these configurations didn't work. I finally found the right combination. Green in the other sensor was ground and red was the output. But this product displays green. Only in China has…

Used these for the boost and fuel pressure sensor on my cts2 edge. You should replace 2 sensors that a hungry mouse ate. They both deviate by about 5psi, checked with a handheld gauge. It doesn't matter as you can adjust the sensor scaling using the cts software. The worst thing, however, is how slow they are to respond. The sensors I used before they were nearly identical tracked much faster. These are terribly slow. I will order others elsewhere and then return or discard these. I do not…