⚡️ Enhance Your Power Conversion Experience with the Progressive Dynamics PD92201V Inteli Power Converter Review

works well for driving a PD 55amp converter. The little green light flashes all the time to indicate what mode it is in. So if you have it in a place where you see it all the time, it might bother some people. I suppose you can always put a piece of tape on the LED? In any case a good product. would buy again.

seriously $24 for what should come with the device when you are already spending $300 is like a big wave. because without this little gadget, there's nothing on the device itself to say what's going on. It's basically an LED soldered to the end of an RJ11 phone cord.

Good product. Essential if your Progressive Dynamics RV power converter does not have one. Allows you to see what mode the converter is in and this is crucial. Mine wouldn't go into "boost" mode, 14.4 volts which is the battery charge mode. The cord could be a few feet longer, but phone extension cords can be bought and used very cheaply. A good product.

I ordered this because it was not clear if one came with the smart charger from the same company became. I should have waited One was bundled with a smart charger. Now I have two. You can return it unopened but it's not worth it. And I will have a replacement. The smart charger seems to work as it should and was a good buy.

The Status Module is probably optional, but I just wanted it in case I needed it in the future. It lets me know what mode the charging system is in and change it if needed. Basically, I can see it's in mode and working fine. This is a simple plug-in device with a foam tape holder. I'd love a device with a digital voltage and charge level display that would look nice in the living room, but that'll do. This is not a device I would want to install in an outdoor living area. I installed it under…

If you wish to replace your batteries with Lithium batteries without switching to a Lithium converter/charger, you will need this so that you can put your charger into fast mode . This is because lithium batteries require at least 14.4V to be fully charged. Installation is simple, connecting directly to the converter/charger. The controls are fairly basic, just a button and an LED that flashes at different speeds to indicate charging status. Just press a button to switch between Boost, Normal…