Prothane 14 505 Motor Mount Insert Review

Good, apart from some inevitable vibration, installs easily as long as it holds up well. Really smooths out the shifts.

Mine came with the wrong instructions. I needed a Spec V but it was for the 350z. It also says there is lubrication, but I don't. Not a huge complaint as the mounts fit and work very well. It just had to be packaged properly so there were no mix-ups.

Took about 2 hours to install. I mostly buy stock mounts. I used a hacksaw to cut the inner ring, bending one side and then hammering a small screwdriver under the cut. This will split the ring and release tension. Then it's easy to knock out. Of course, the easiest way to squeeze is if you have a press or take it to the store. Pushing it in wasn't that bad. Modified the spring compressor with spare pieces of wood and large washers to fit the new bearings. Use lots of lube.