Header banner
Revain logoHome Page
πŸš€ quicksilver distributor sensor 892150q02 - thunderbolt for v6 and v8 mercruiser marine engines logo

πŸš€ Quicksilver Distributor Sensor 892150Q02 - Thunderbolt for V6 and V8 MerCruiser Marine Engines Review

3

Β·

Poor

Revainrating 2.5 out of 5Β Β 
RatingΒ 
2.3
🧯 Ignition Parts, πŸ› οΈ Replacement Parts

View on AmazonView on Π―M

Media

(4)
img 1 attached to πŸš€ Quicksilver Distributor Sensor 892150Q02 - Thunderbolt for V6 and V8 MerCruiser Marine Engines
img 2 attached to πŸš€ Quicksilver Distributor Sensor 892150Q02 - Thunderbolt for V6 and V8 MerCruiser Marine Engines
img 3 attached to πŸš€ Quicksilver Distributor Sensor 892150Q02 - Thunderbolt for V6 and V8 MerCruiser Marine Engines
img 4 attached to πŸš€ Quicksilver Distributor Sensor 892150Q02 - Thunderbolt for V6 and V8 MerCruiser Marine Engines

Description of πŸš€ Quicksilver Distributor Sensor 892150Q02 - Thunderbolt for V6 and V8 MerCruiser Marine Engines

For use in MerCruiser stern drive engines made by General Motors using Thunderbolt IV and V ignition systems. Easy to install with common shop tools. See your owner's manual or service manual for specific applications and replacement instructions. Produced by Mercury Marine to our stringent original equipment manufacturer specifications to maximize the performance of your Mercury and Mariner outboard or MerCruiser stern drive.

Reviews

Global ratings 3
  • 5
    1
  • 4
    0
  • 3
    0
  • 2
    0
  • 1
    2

Type of review

Revainrating 1 out of 5

Thank you for the used part with missing parts.

This is obviously a used part, there are no components in the part. I will definitely come again. Unfortunately we also have to cancel our boat day tomorrow. On a positive note, it was delivered quickly.

Pros
  • Replacement parts
Cons
  • poorly thought out

Revainrating 5 out of 5

Perfect with 1 installation note

problem fixed. Fits right hand .89 Mercruiser 4.3L. In a setup for an 89 Mercruiser 4.3L, instead of grounding my wiring to the flywheel ground as instructed, I had to remove the ground from one of the old two-wire sensor's rack wires and use the existing ground and remove it from the two-wire installation. The new sensor had three wires, the old sensor had two wires, the one on the old sensor was a combined ground.

Pros
  • distributors
Cons
  • I will say nothing

Revainrating 1 out of 5

Revain left it out in the rain

Updated One Star Rating: The rating has just been updated to one star. The part is defective and I could not start the boat. I cleaned the old part and put it back in the boat and the boat started right away. I am returning the part for a full refund. Original two star rating: product appears to be good despite Revain being out in the rain. I have a covered porch and for some reason they put it behind the air conditioner instead of going on my covered porch. I think I would give the product 4…

Pros
  • Distributors and parts
Cons
  • Lots of stuff