✂️ QWORK Adjustable Cutter with Replaceable Blades, 40-200mm Review

The instructions page for the tool is not very good. And you must be careful to follow the blade alignment pattern. My blades were installed as NO-NO as stated in the instructions. The instructions don't say anything about the two screws on the outside of the bar that hold the blades, but I learned about them quickly. If the screws are not tightened (they don't seem to do anything - I don't know why they're there) they will loosen during operation and start rubbing against the inside of the…

I needed to install 8 consoleless lights in my home office. I do crafts and have done before, but drywall dust is such a mess. I've seen this on Revain and although it would be great for cutting perfect holes with a bit of a mess. I was wrong. Read the instructions carefully and set them up. Make sure the blades are in the correct position and are tight. The first hole went well. I thought I was a genius for finding this little gem. The second hole seemed to go well too, but I found the blades…

I have used this tool for 6 holes in drywall for LED panel lights and even if I never use it again it may be the best money I've ever spent on a DIY project. I spent 20+ minutes reading the instructions and setting up the blades for my first cut because I'm meticulous. Based on a few negative reviews it looks like they misadjusted the slicers. Now that I figured out the tool, it only takes a few seconds to set it up again. At first I thought the blades were weird in opposite directions. (one…