🔧 Raider 1906018 Universal Shut Off Valve - 90 Degree Rotation (Fits 1/4 inch Line) Review

Was easy to install and was a much needed plastic upgrade. Only time will tell if this one is any better, but considering the plastic has lasted 20 years, this one will likely last longer. Well built and turns smoothly.

I added this to my snow thrower so I can drain the carburetor when storing it over the summer. The first season worked fine, but now it doesn't shut off the fuel supply. Good idea it seemed well built but other reviews are correct. It's garbage.

Replaced the plastic fuel tank on my 5hp MTD snow thrower. It's plate mount so I installed it in the same metal box as the carburetor. Perfect. I couldn't remember how the plastic was supposed to queue. I also replaced the fuel line with .25" rubber. Much better

I have installed two of these generators on each of my generators. They work great and with them I can 100% drain the fuel from the carburetor. I hope I never have gas paint clogging the nozzles. The hardest part was figuring out how to route the gas line from the valve to the gas tank around the air filter. I would recommend this to a friend.

Best Small Engine Fuel Shutoff Valve for my Toro 724 Snowthrower. I replaced the original metal needle valve as it no longer shuts off the fuel. I like this valve better as it's a ball valve and has a red lever that shows exactly when it's open and when it's closed. I've tried the common red plastic valves used on new lawn mowers and snow blowers. But this guy loses fuel when brand new through the outer o-ring. This valve lasts much longer.

I have a 23 year old snow blower. The carburetor always clogs with a mixture of oil and gasoline when not in use. Usually I have to replace the carburetor. this year it burned down in a year. So I bought this connector, drilled through the faceplate and added a fuel filter and it shut off. then replaced the carburetor again. This should make it easier to run the pipelines dry instead of pumping the gas. The new valve rotates easily and is all METAL. I just wish there was a drill size guide…