🚘 2018 Jeep Wrangler JL Sport/Sport S: Pack of 9 Red Front Grille Grill Inserts & Headlight Covers Trim Review

The company originally supplied a flat black and a gloss black headlight bezel but fixed the issue as soon as I let them know. The product went through without any problems and appears to be safe. Grid inserts are easy to assemble. Headlight inserts can be a bit tricky. I would advise you to find and mark the best position before removing the foil from the tape. If you put the bezel on and think you can turn it into the right position, you are making a big mistake. The bezel doesn't move once…

Disclaimer: WILL NOT FIT 2019 Wrangler JL Sahara. The left and right headlight inserts are too thick to fit securely into the body. I even had to remove the Wrangler's front grille to see if it would fit differently, to no avail. Too bad, because the quality is okay, but neither the grille inserts nor the headlights fit. There's Silver in the Sahara already, and I believe that applies to Sport trim levels ONLY. Attention buyers! returned mine

They look good when properly installed. As other reviewers have pointed out, the headlight bezels have a left side and a right side. Also, when installing the grill parts, I learned that if you put the top in first, then push the sides together and put in the bottom, then push the sides back and out. This way you get a snug fit without the translucent color of the front grille between the inserts and honeycomb. They were also good enough to include more tape if you need to uninstall and…

They come with no instructions and you won't think you really need them, but here are some tips on how I made it. When installing grill parts, start at the top first as there is something flat to dock onto. Lightly glue on the upper part, then guide the lower part evenly. When you're done, fully insert the top, bottom, and sides. As someone else said, you need to dry and mark your headlight guard first. It's almost impossible to get them perfect as the grill will bend a bit. But overall very…

Before and after photos; The look I was aiming for. Important tips: - Clean the areas to be pasted with an alcohol wipe - Carefully (precisely) align the headlights without covering them with 3M tape. Mark the 6 o'clock position with a fine pen (auto and insert). Remove the protective tape, start at the mark and slide up. Once inside, apply pressure with the micro-weave as you move. Use a hair dryer to improve adhesion. Same procedure with grilled pieces. I used masking tape to mark the bottom.

I've thought a lot about what I think of this product and thought I should write a review. First of all they look amazing and the build quality seems good for plastic parts and I've been wearing them for about a month. However, the minus I have is the method of installing them. They come with double-sided mounting tape (and lots of extras that I've used very little) that add extra thickness, resulting in gaps in places that ruin the original manufacturer's look. However, you won't notice it…

Really nice even with an extra roll of double sided tape even with the parts attached just in case you screw up. Put it on the difference between day and night. Very happy with the fact that they are not shiny, transparent or black when wet sanding. Remember, if you have anything other than a base JL Wrangler, anything above a Sport or Sport-S won't fit. I would suggest dry mounting first, also placing at the top of the angle of each grid insert first so the 3m tape doesn't touch, you want them