Red Hound Auto 2013 2019 Compatible Review

They fit my 2018 Escape SE and they look good. The installation took about 15 minutes, the wheels did not have to be dismantled. The only catch with the installation is that the bottom hole on the front flaps doesn't line up exactly with the mounting hole (it could be 3/8 inch). They still look pretty solid without a clasp.

I like the product. I like how they look. Better factory and unimaginable. Difficulty 1 out of 10 - 3. I put them on without taking the wheel off, taking the wheel off would be easier but not necessary. do I recommend them? Yes absolutely. Strong plastic. a light weight. The back has 3-7mm screws and comes with a strong metal clip for the bottom. Very satisfied.

I like it very much. I just installed them today and almost all of them installed in about 30 minutes. They fit perfectly and the hole alignment was perfect too. Note that I didn't have to remove any tires or anything. The tools I used were a 7mm socket and since I didn't have a pin puller I carefully used a pair of wire cutters to pull the pins out (being careful not to squeeze the pliers).

I bought these for my 2017 Ford Escape, everyone is complaining that the front valves have a bottom hole that doesn't match the factory clip but I found out that when you put this clip in first, you can bend the inside of the wing to fit. The front and back have slight fit issues (see pics) but look fine from 10ft and have no functional issues. I recommend them, strong, the color matches, they look beautiful.

Looks great. Looks like a factory install. The instillations weren't that bad. Behind is better installed when the car is jacked up. The front only has to rotate the tire to make room. The only reason I didn't give it 5 stars is that the bottom hole underneath isn't aligned very well. But it will work if you snap it into place before securing the in the wheel well. You need to pull back hard and tilt the clamp a little. It is not enough if you first insert one of the wheel arch clips.

It takes about 15-20 minutes to assemble all 4 sheets. The edges on the valves are rough. Not so much, but noticeable. The 2 front flaps don't match and the hole on the bottom doesn't match. The material makes a fairly hard-wearing impression and offers good value for money overall. Minus 1 star for jagged edges and poor front valve seating, but better than paying full retail price for a genuine Ford product. All 4 valves come in a box, well packaged with clear instructions.

These fenders were advertised as requiring no drilling and using existing factory equipment. They fit exactly as intended, they look like a factory installed damper and work great with all existing equipment. The only recommendation I would give is that if you have a ratchet like I do, it will be very easy to install the rear flaps without having to jack up the car or remove the rear wheels. These are very high quality patches and we are very happy with this purchase.

Can't say for sure. But every day I drive to and from work the same way. I average less mpg. I usually average close to 24mpg. Because if you add them, it's difficult to average over 23 without an absolute nanny. There were also bumps on the back that needed to be cleaned with sandpaper. They appear to be durable but upon closer inspection I'd give the fit a 5 out of 10. Having said all that, I would dry another brand if I were to buy them again. Not that another brand would have influenced the

It's okay but the front fenders were marked on the back. Right was left and left was right. Also, the tab on the underside of the faceplates didn't fit close to the mounting hole in the machine. I fought but didn't leave. Finally I cut a hole in the guard up to the keyhole and since the clasp had a large head I was able to secure the guard. Looks great, but it took me 72, an hour and a half and 19 tools. If you are old and have difficulty getting up and down from concrete, this is an…