🚿 Enhance Shower Experience with Moen 145058 Shower Adapter Replacement Part - Convert Standard Valve to Moentrol Valve Review

Great product and a must have if you have an old Moen shower valve. I installed Moen T8350 pads with this adapter and they look really great.

This part allows Moen to upgrade retrofit old valve assemblies on any Moentrol Pressure Relief Trim Kit. I used it to update a beautiful old bathroom with a new look. I installed a Moen T3111 single metal lever handle trim kit from the Kingsley collection. Including a great new showerhead and spout, my total cost for twenty minutes of installation was less than $100. I am very satisfied and my wife is also satisfied.

I wanted to install a Moen T187 fairing on my 25 year old Moen shower valve to match my other Moen shower valve. This worked but had a few problems. 1) The threaded holes weren't spaced correctly so I flipped that around and drilled/cut the holes the right distance. 2) The pad was noticeably uneven and I found that the correct threaded hole location for the bottom screw was slightly offset from the existing hole where the screw should have been. After a lot of work involving the use and…

I recently bought a 2001 townhouse. The two full baths have one-piece tubs and water showers that fit into an alcove, making it impossible to access the valve system without removing the entire system. Unlike tiles, which can be carefully removed and replaced, they must be cut and cannot be repaired without leaving noticeable marks. It is in very good condition except that the fasteners were polished brass. I wanted to upgrade them without changing the valve, which turned out to be a difficult…