Enhance Your Lighting Setup 💡 with RGBSIGHT Single Extension Conductor Lighting Review

Good quality cable for the applications I've used it for e.g. B. to connect my stall to LED strips from a 12 volt battery. It's easy to use. I haven't tested the wire gauge for accuracy as I don't push the current limits too far and allow a bit of headroom in my current handling skills.

Decent quality cord. I've used it to power RGBW LED strips so you're not limited to one color when connecting data in other ways (I used JT-2 connectors with their own pigtails). Data and power were connected at different points in my project, so I didn't need more than two conductors for power.

Exactly what I needed. The quality seems to be good. Note: The wire is not copper (probably aluminum). Same as 18 gauge. I measured about 0.96mm on red and black with vernier calipers. The AWG spec says 1.024mm for 18 gauge, but that's close enough given the accuracy of my measurement technique. I haven't seen any discrepancy between red and black thickness that others have reported. Not saying they're wrong; I just didn't have that problem with this coil. The red and black wires separate well…