🏍️ Rox Speed FX Street Riser 2" / 1 (Black) - Enhance Your Riding Experience! Review

Riser works as it should (if a little pricey). The installation takes a lot of time to ensure that the cables and wiring are not overtightened, some diversions are required. Otherwise a quality product. Much better riding experience on my 2020 Yamaha Bolt R spec.

Installed on a 2018 HD Heritage. Fairly easy installation - 2 jobs with no cable changes, but hardly - you may need to reposition the clutch cable. Can be adjusted in many positions. Try it out and see what works best for you. I did it myself but 2 extra hands is better.

Just right to bend my elbows a little and take the pressure off my shoulders. You can't go beyond infinity when talking about customization. On my 2012 Yamaha VStar 950T all the cables were fine. Throttle cable at maximum length, but not tight. Installation was easy, especially after the seller helped me. .

So these "risers" should only be used when you need to pull the bars much closer towards you than up. If you need height, you'll definitely need at least 3 "spacers, if not 4". 80% of the height of these spacers must face the rear of the bike (or rider) to gain access. on the bottom of the screws to tighten them. If you attempt to position the risers directly over the bottom section of the riser bolts, they will be blocked by the mass of the risers and you will not be able to tighten the stock…