Fuel Filler Door Gas Tank Cap Cover Accessories for 2007-2017 Jeep Wrangler JK & Unlimited Sport Rubicon Sahara – Carbon Fiber Grain Finish Review

The most difficult part of this installation is pulling out the old protective insert. It's quite difficult to detach the tabs, especially on the back. The instructions were all pictures but they say a picture is worth a thousand words. It would be nice to drop a few words to find out where you work. Finally, I went to YouTube to see how to replace the insert. It was great and way better than the instructions. I had a problem. The insert's alignment tab was on the left edge and the alignment…

Appearance and finishes are fine. The 9 o'clock alignment tab is plastic and does not fit properly into the existing hole in the case metal. I had to snap it off to fit. The instructions are rudimentary, Youtube helps with this. Still spins a bit if you put in some effort. Seems comfortable enough to hold his position as long as nobody messes with him. The time will show. Installation = Remove the rear light (light does not need to be turned off, just leave it hanging). Press on the 2 securing…

Alignment tab is located at 9 o'clock on the plastic bucket insert. On the Jeep, the hole is at 12 o'clock, so the new bucket spring needs to be removed. This "spring" stops the rotation of the plastic bucket and door. When the "pen" is cut off the new bucket, there will be some movement/rotation. The old filler neck and plastic bucket gasket must be reused as the new gasket is too thick and will cause the check engine light for the EVAP system to come on. I have chosen not to return this item…