🔩 Rugged Ridge 11156.98 Interior Trim Accent Kit in Chrome Review

Looks good and goes well with my jeep. The included tape doesn't stick properly, but these pieces are easy to install and feel solid for now.

Most of the parts in this set just look cheap and some of them are not big enough to cover the area. The lining around the door handle prevents the door handle from opening evenly. Some parts fit well but the kit is a waste of money.

the middle where the shift knob doesn't fit or something like that. Not sure if I got the wrong pieces or something, the middle two pieces don't fit perfectly but can do. TO UPDATE. ALSO THE CENTER TWO PARTS OF THE RADIO DO NOT MATCH VERY WELL.

not worth the money. Some parts fit perfectly while others stick out too much and look like cheap Autozone junk. Also, the strips they use to hold them in place are flimsy. I only use replacement vents from the entire kit. Yes, and the large side pieces of the column didn't even come close to matching in size.

I bought this fairing for my new jeep. Couldn't believe the price compared to Jeep catalogues. It's the exact same part number. There were a few broken parts, Revain picked them up from me and quickly delivered new ones. Every part fits perfectly except for the two side dash panels that run on opposite sides of the radio and climate control panel. If it wasn't for that I would have given 5 stars. Now I buy everything I can from Revain. Great prices and great customer service.

First of all I want to say how much I love how much I love to decorate my jeep with this. I have an 08 Unlimited Rubicon and it accentuates the interior enough without being over the top. Now I had a problem. The tape doesn't hold up very well. I had to use spray adhesive on some parts to keep them in place. Mostly on the rear doors and parts of the center console. I waited for it to warm up, then turned on the heat and let it warm inside for a good 30 minutes before installing it. Still didn't

quality parts but not for new installers -- instructions in each box for each part -- nice to see -- double sided tape not enough to hold part of fairing in place -- I use 2 parts epoxy for plastic , drying time, which was 10 minutes. You just need to clean everything well with alcohol wipes and wipe with tape. I don't intend to remove the trim pieces so I didn't bother gluing them on - none of the pieces interfere with removing any part of the car. Great care must be taken when installing…