🚐 RV Step Motor 300-1457 1010002326 25 Series New 369506 094707-05-701 - Efficient Motor for Your RV Steps Review

It arrived quickly and was very easy to install. I'm certainly not a mechanic and I succeeded. You might need someone to hold the levels while you change them, but otherwise this is a very easy fix.

Pretty simple, installation was easy, be sure to keep the original rubber gaskets and screws, they are not included. Works as advertised. Only negative, found out it was $20 cheaper on their website.

I actually used the internals from this motor to build a similar motor (with a different gear size) for a sliding side door on a disabled van. The internals looked just as good as the original, and the end result was a working solution with an affordable and quick fix compared to what is probably a fairly expensive mobile component OEM.

This motor was perfect for the Kwikee Steps Revolution. It stood perfectly and the fork worked without any problems. I saved a lot of money by purchasing it and it runs smoothly and quietly. Now, a year later, the engine does not close the stage smoothly. At the top, when closed, it cycles on and off until it locks after about 12 times. I'm afraid it will fall off while driving.

Product installed in March, received in January 2020, the state was disabled, the motorhome could not be used when it was finally possible to step all the electrical components works not, guarantee per step if possible i can get a replacement or refund purchase for this step i decided not to allocate any further amount of money when i was not satisfied with the product received and the poor performance step was returned to the seller and the money was was without Questions sent back, did…

motor built in, tried it out a bit because my stepper motor was on the side wall of the step. Aligning the spacers and screws was a bit of an issue. Keep gaskets and bolts away from the old engine because you won't have a spare. I'm glad I did. Make sure the step is in the locked position by removing the motor as the steps will fall down when the motor comes out and your hand will not be blocked. Leave the steps in this position to reinstall the new motor so you're good to go. I am very happy…