🔌 Meetou 2 Pin Plug Replacement Weather Cap: Waterproof Cover Cap for SAE Connector (25pcs) Review

Used to protect the sae fittings on my boat. Doing their job well. Made of good material. I have one fitting without and I can tell the difference. Wish I could order just one.

You get tired of driving from place to place looking for an item, wasting time and gas. these were just what we needed. That's my review!

I needed this cap to control corrosion in Hawaii’s warm humid acidic environment. The retainer keeps it attached to my cable. I use a small amount of dielectric grease on the contacts, and the cap prevents contamination.

In the winter the plastic tethers tend to snap in the cold, so these are great when you loose the originals. The covers may be expensive for the quantity and quality received.

Use a 12mm/.47" split ring available in craft stores like Michael's or from a fishing supply store.Thread the SAE wire through the split ring followed by the farthest loop.

Didn't find any problem with these as others have stated. Well constructed pliable rubber. Fit all the SAE connectors I have from Battery Tender and more. You can make a loop with these to put on wires that have a cap that broke off, I usually use a super small tie strap or just use electrical tape to tape the two loop end to the wire, seems to work fine.

They work but unless you are cutting the cord to install them you need a tie wrap or another way of fastening then to the cord

These fit the typical SAE 2 pin 12V connectors. However, there are two big flaws:1) you can't thread the wire through the little rings at the end unless you cut the connector off the wire. You are stuck with zip-tying them on or coming up with some other method (and the zip tie will eventually break the rings in the cheap rubber)2) Assuming you figure out a solution to the above, the tethers are cheap and weak (and break especially easy in cold weather). This is the same problem I had with the…

As a result of my tests, I determined that these waterproof caps are essential for any outdoor electrical connections to prevent contact with water or debris. The caps seal tight and stay securely in place, keeping electrical components safe and functional. The only downside was that they were a little tricky to install at first, but once I got the hang of it, it was smooth sailing. Overall, I highly recommend these waterproof caps for anyone looking to ensure the longevity and safety of their…

good to have back up plugs if you loose them, i used a small zip to attache better, cuz i tried to stretch, and brokegood price for some backups

These caps break, get lost, and therefore don’t last as long as the cable they’re protecting. These caps do their intended job, though I question how waterproof they might be. The issue is that there is no way to connect them so they remain attached the the cable. The two holes in the tail of these caps are far too small for the SAE fitting to go through them, and the cap itself cannot either, so no way to secure the caps.