🔍 Enhance Your Polaris General with Seizmik Mirror Mounts [18069] Review

Fits perfectly. My only concern for clients are those who need a full body. They could indicate a problem if they go past the door jamb.

Well made pressed steel. the angles were right and the mirrors placed in a good position. The screws you use don't quite go back to where they were, but I haven't had any issues with this install yet. In general I am very satisfied.

I bought these to fit Seizmik mirrors on a Polaris General. This bracket allows you to use the factory bolts on the cage. These brackets also make the mirrors flush with the car. Very easy to install, highly recommend.

Very easy to install and keeps the mirrors secure. Used with the following Seizmik mirrors: Seizmik UTV Folding Side Mirrors (Polaris Pro Fit) https://www.amazon.com/dp/B01IE42C68/ref=cm_sw_r_u_apa_i_XMXJFbQ0020JA?_encoding=UTF8&psc=1

The biggest problem was keeping the bottom nut in place so I could get the bolt to connect. I dropped three screws in the case and had to buy a replacement. Before fully unscrewing the bolts, it is recommended to wrap a strip of tape around the nuts. The rest of the installation went smoothly.

That should be included with the Pursuit side mirrors. They have eliminated the upward tilt of the mirrors that occurs when using the included Pro-Fit clips. The mirrors are now aligned and looking straight at my general. Be careful not to drop the nuts when installing, otherwise they will be difficult to get out!

Ideal for fitting mirrors to your General. But on my G4, the Polaris top doors and brackets don't play when the door opens and closes. I ended up turning them upside down and bending the brackets a bit. In retrospect, I could have mounted them correctly and bent the brackets the other way around. Another note: the mirror bolts are too long, so you will need shorter bolts.

If you want to use these mounts on a 2016 Polaris General you will need popsicle sticks and a Blu Tac. When removing the corresponding bolts, the nuts are inside and in a hard-to-reach place. Take a popsicle stick, place a piece of Blu Tac on the end and glue it to the nut. Once the nut is free, she won't fall into your roll cage and you can carefully maneuver her around. Do the reverse when reinstalling the bracket nuts and bolts.

This is a must when installing Seizmik Pro mirrors on Polaris General. You would think that Seizmik would have included these brackets in their mirror kit instead of the brackets that came with the kit after they told you they would fit the Polaris General with the brackets that came with the kit. The brackets that came with the kit caused the mirrors to be set at an angle and not look straight. And these brackets solve that problem. But I've increased the cost of the mirrors, and I'm giving…