🦈 SharkBite 1 Inch Brass Push-To-Connect Straight Coupling Fitting for PEX, Copper, CPVC, PE-RT or HDPE Pipe - U020LFA: Seamless Pipe Connection Solution Review

This is a great product, very easy to use and the supplier is also very responsive. You can't go wrong with this item. Simply cut the tube to the required size, press and you're done.

I have never used Sharkbite fittings after many years of plumbing work. I have used them on hard copper pipe. All I did was clean both mating copper tubes and they just slid in. No leaks at 110psi.

Charges everything. My local hardware store will only deliver if you buy a certain amount, even if you're willing to pay more. I try not to travel into town in the middle of a project. It is excellent!

Amazing product. I used this instead of sweat on Union and it worked like a charm. Super easy to install and no drips. You can also remove it. While I love sweaty copper, such a simple product is hard to miss.

Apparently not every monkey can handle this properly. Before inserting the tube, make sure the floating insert is aligned in the coupling, otherwise it will twist and become impossible to remove. Other than that, these things are great.

I needed this when replacing the brass ball valve in my underground sprinkler system. This was part of the plumbing work in my basement and worked fine. I have used SharkeBite products before and have never had a crash. Some fixtures have lasted five years.

It was $10 cheaper at Revain than my local hardware store. It cost me about $35 to fix my pipe by cutting out the 5" center section and adding a new piece of copper pipe with two shark bite connectors. zero leaks. However, they are a bit difficult to remove. I discovered this after realizing my middle pipe was 1/2" shorter and I had to start over. It would have cost $75 to have a plumber come to me without the work. Great homemade product.