Premium Quality Sierra International MP39760 Medium Ignition Switch - Efficient and Stylish White Design Review

Fits my old boat but the connectors were labeled differently. However, it wasn't difficult to understand which wire went where.

The switch on the pole is defective. Turns around, but does not return to its original position after launch. It just stays in its original position all the time. Request a replacement or refund

the ignition does what it's supposed to do unfortunately the rod wasn't long enough to fit so I had to modify it a bit. Looks like cheap plastic, but let's see how long it lasts in the sun next summer.

Works great. I bought a boat with a 1968 Chrysler engine that didn't have a key. I bought this ignition switch, it was easy to install and the outboard was up and running in 10 minutes.

replaced the OEM almost perfectly, the only problem I found was that one of the OEM terminals had an A and the other an i. It was a lot cheaper than making a new key, took about 20 minutes. to replace, be aware that most older boats have very few extra wires, it was a pain trying to get all 6 back, old hands and bad eyes don't help LoL either. I took notes on what color went into what I shot a few shots and got it right the first time! delivery 2 days with prime.

Product came in perfect condition, 3 positions, press to accelerate, same number of ports as the one I replaced. It's very easy to move wires one by one from old to new in the same position. I didn't have to worry about the colors of the wires, the position just fitted. Total installation time 15 min. And it works perfectly. Look at the location of the terminals on your boat and match them to the new one with the same number of terminals located in the same locations as yours and make sure you…

Ignition switch works fine but the terminals are not in the same position as on my 1978 Evinrude Power Pilot. I had to lengthen and reroute the main power wire (B) to avoid contact with the magnet wire (M). , since the factory does not leave much room for manoeuvre. Also, the installation diagram wasn't 100% accurate, which combined with the difficulty in reading the terminal labels meant I didn't connect the switch correctly at first. This ignition switch was not a direct replacement - it is…