🔦 SIRIUSLED - FT- 7440 LED Backup Reverse Light Bulb Super Bright High Power Single Filament with Air Vent Design 3030+4014 SMD White 6500K - Pack of 2 Review

Installed as a reverse light on the 2021 Ford Explorer. The bulbs fit snugly and click a little when properly seated. I think they could be a little brighter but still better than the bulbs that come with it. There is no notification of a blown bulb.

The product has very good packaging and detailed information on the packaging itself. I received these LED lights to replace the halogen reverse lights on my 2016 Explorer. The LEDs are very bright compared to standard halogen lamps.

Received them today and was trying to install a bulb. The LED light bulb was broken in two and fell into a tight corner of the car and I can't get it out making it impossible to return for a replacement or refund. I do not recommend for the quality of the product. Don't buy this.

My wife wanted to see backwards better at night, well here it is. Illuminates most of the road and is very clear to them now. Installed on a 2009 Honda CRV Sport, pretty easy to install. Remove 4 small plastic caps, unscrew 4 screws, plugs, pull out lamp and install new 1s and vice versa. Done ✅

Installs them on a 2020 Toyota Tundra for reversing lights. I was a little hesitant as there weren't many views, so I gave it a try. It's been about 5 months and they still work. They are very bright compared to ordinary light bulbs. To date I have not had any problems with them and I am completely satisfied. The lamp felt and looked great and it is a great recessed lamp. Today I would buy them again at any time.

These guys fit perfectly - they snap in just like the original bulbs (make sure you press until you hear a click). Brightness is very good, although not much brighter than the original bulbs. but they're much whiter and seem to illuminate the area better than the honey-colored "dying flashlight" of the originals. I took the attached photo after just replacing the left one to show a fair comparison - don't trust photos that show ONLY new bulbs OR just old ones, camera exposure varies too much to

Installed after some work on my 2016 mx-5. The LED reversing lights (Osram/Sylvania) I installed a few years ago were not as bright as the stock bulbs. On the first try I didn't realize how weak the Sirius LED was and it fell into the case. So I pulled the whole case out and rotated it so the LED would fall out. It turned out that the shank (the flat part where the contacts are located) is a few millimeters longer, which does not allow for correct installation. So I folded the contacts back…

I have replaced the brakes, turn signals and reverse lights on three of my cars. I bought them as a backup because they were cheaper. What mistake. I actually bought these for my Mazda3 by mistake, the 7440 is too big for 3 so thought I'd try them on my Mazda MX-5. He climbed under the car, took off the old headlight, put in a new one, went to install it, and it came into the body. I thought I screwed it up. It became a great agony getting in there and removing the case so I could pull the bulb