🔥 Pack of 10X 900M Soldering Iron Tips Compatible with HAKKO 936, 937, 907 Atten, Quick, Aoyue, Yihua, Vastar, Sywon, Tabiger, SOAIY, and X-Tronic Soldering Stations - 10 Different Pieces Review

I was looking for tips for Xtronic 3010 and they fit so I bought them and was going to fit one today and they are too big and don't fit. It's about 10,000 more as far as I can tell, and none of the nozzles in the kit will fit.

These 900M Series Nozzles fit a wide variety of irons available here at Revain. They fit great, heat up quickly and do a great job when soldering. The tip itself is pre-tinned, and the body and shaft are beautifully chrome-plated. As with all soldering tips, be sure to keep them clean while you work and apply a small amount of solder to the tip before turning off the iron to avoid oxidation.

I just bought these tips to replace worn out ones that broke in my Aoyue machine. I don't know what these tips are made of, but they don't tin, they react with the solder paste and immediately coat the tip and barrel with a weird black coating. I removed SOS it and it did it again. The gaps are wrong, even if the element does not reach the top, the head does not heat up and periodically cools down.

Just received and just tried a few tips. With a LONOVE 926 soldering station. (Not listed in the description but they fit. I took a chance they would). After initial conditioning and peak testing; The tips seem to transfer heat very well. I ran temperatures up to about 850F. I've only had them for a few days and will see how they fare in the long run. As with any advice; They require maintenance and seem to last a long time. They're working great so far.

Hello! This soldering iron tool set is terrible. I use a HAKKO soldering iron and bought these tips as accessories to learn how to use more tips for soldering projects. They failed miserably because they don't even fit the soldering iron they are advertised for! The quality of the tips is terrible too. I haven't been able to use them but they don't seem hard and in fact if you look at the bottom you can see these tips are hollow! They are not the same length and diameter! In the photos, the…

Honestly, that's a great value. The galvanic plate is quite heavy, I used it to iron a 3D print and used it for quite a long time, 20-30 minutes, completely dry and intact, it blew off the coating, the tip did not peel off and is not oxidized that much that it was deformed. Cheaper tips have smaller heads than this one. They're sharp, with nice, even edges, and heat up quickly. They transfer heat well and are easily wetted. I had to use acidic solder paste for one of my projects and I hate…